Mathmos Neo Lava_lamp - Instructions
ASSEMBLY INSTRUCTIONS
POSITION
- Choose a position inside on a clean and horizontal surface.
- Do not place near sources of heat or cold, such as a heater or air conditioner. The product operates at its best in a room between 68º F/20º C and 75º F/24ºC.
- Keep the cable away from heated surfaces.
- This product is not suitable to be set up on glass surfaces.
- For best performance, we recommend you keep the product away from sunlight to prevent fading drafts and cold places to prevent slow operation and freezing, hot places to prevent overheating.
- For indoor use only.
CHILDREN
This product has been manufactured to relevant safety standards. However, for use with children, we suggest to ensure that the product is not knocked to the floor and that you fix the product to a surface, see below. When Neo is not fully assembled do not leave it in reach of children as it contains small parts.
SETUP
This product comes with 8 components:
- Base
- Bottle
- Long arm piece
- M4 Screw x 1
- M2.5 Allen key x 1
- Switching power adapter
- UK interchangeable plug
- EU interchangeable plug
To assemble:
- Place the base on a stable and flat surface. OPTIONAL: The base ring has x2 screw holes that allow you to fix the base (if required) onto a suitable flat even surface. We recommend you use suitable screws (x2 of the same specification) for the desired surface you will be fixing the base onto. You must ensure the base is positioned and secured safely onto the desired surface. Once fixed, the base should be free from movement at all times. (fixing screws not supplied) (figure 1)
- Take the bottle and place the long arm piece over the top of the bottle and push in place (figure 2)
- Firmly hold the bottle and arm piece using both hands and carefully place into the base and line up with the screw hole on the base - please do this by slotting the arm piece into the cavity (below the screw hole) in the base. (figure 3)
- Insert the screw provided and tighten with the Allen key till firm (figure 4)
- Slide the correct plug (EU plug or UK plug) onto the switching power adapter until it clicks (figure 5)
- Plug the switching adaptor provided into base cable port. Plug the product in and turn it on (figure 6)
WARM-UP
Warm-up takes between 1-3 hours depending on the surrounding temperature. Stalagmite shapes may form during the warm-up process, these will then melt and the lava will begin to flow. It is normal for the glass to have small air bubbles and moulding scars.
OPERATION
- Your Mathmos product will operate best after it has been used four or five times. For the first few times, you may see small air bubbles in the lava. Please note the heating time will decrease after several uses.
- Please do not leave the product on for more than six hours a day or allow it to overheat; this will prolong the life of your product. Overheating will shorten the life of the product; if it is overheating there will be either only one large bubble at the top of the bottle or a lot of very small bubbles.
- Never move or shake the product when it is in use or still warm, as this causes irreparable clouding.
REPLACEMENTS
When your product has ended its life it will begin to go cloudy, the colours may fade and it will not move as well as it once did. This will happen after approximately 2000 hours in operation. Whether your product has ended its life or when you wish to have an alternative colour combination, visit our website at www.mathmos.com for more information on a replacement bottle or full product. Please note we do not refill bottles. Please on no account open the secure cap and add liquids.
If the bulb blows, please replace it with one of the same type and wattage. Only fit the correct bulb, as stated in the label in the base. Visit our website at www.mathmos.com for more information on replacement bulbs.
IMPORTANT! Always allow your product to cool down completely prior to handling or moving the product.
Once your product has completely cooled, using the Allen key provided to unscrew and remove the back screw out (keep these components safe). Carefully, holding both the bottle and arm piece, lift and remove the bottle and arm piece from the base. Carefully take the arm piece off the bottle and place it onto the bottle you would like to use. Now refer to ‘set up’ for instructions on how to assemble.
SAFETY INSTRUCTIONS
- This product carries the statutory guarantee of the country of purchase and meets all the applicable standards requirements. Use this product only for its intended use as described in these instructions. Do not use attachments not recommended by the manufacturer.
- Do not use any other means to heat up the bottle other than the bulb provided nor attempt to cool it down artificially.
- Do not operate the product for more than 6 hours a day.
- The liquids in the product are not dangerous and can be disposed of normally (for details, see our online FAQ’s at www.mathmos.com). If the liquid is swallowed by mistake, drink plenty of water. If any symptoms appear, please visit a doctor.
- Never use this product if the bottle has been dropped as this will create weakness; obtain a replacement bottle and dispose of the old one. If the contents are spilt, please dispose of as much liquid and lava as you can remove, then use recommended cleaning methods for removing coloured water and wax for whatever floor you have.
To reduce the risk of burns, electric shock, or injury to persons:
- Unplug from the outlet before putting on or taking off parts or before cleaning.
- Never operate this product if it has a damaged cord or plug. If it is not working properly, if it has been dropped or damaged, or if it has been submerged in water.
- The external flexible cable of this product cannot be replaced. If the cable is damaged, the product shall be discarded.
- To disconnect, turn the switch to the off position, then remove the plug from outlet.
- Never touch the bulb if the product is switched on or if it has just been switched off to avoid burning. To replace a defective bulb, unplug the product and let it cool down sufficiently.
The product manufacturer cannot be made liable for damage or injury caused by improper handling, installation or use of its products.
cloudy bottle - bottle cloudy - cloudy lava lamp - lava cloudy
glass imperfections - imperfections glass - bubble glass - small bubbles glass - bubbles bottles - bottle bubbles
If your lava lamp does not warm up in this time it may be positioned in the wrong place or the room may be too cold. Lava lamps should be positioned away from drafts and air conditioning. The room should be at least 20 degrees centigrade.
how long warm up - how long start up - lava lamp start up time - lava lamp warm up time
lava stuck at the top
bottle throw away - dispose bottle
lava lamp liquid - new liquid lava lamp - refill - buy new liquids - buy new wax - buy new lava
lava lamp cap - cap lava lamp - buy cap
wonky lava lamp - wonky bottle - bottle wonky
lava lamp lifespan - lifespan lava lamp - lava lamp last
which bulb - buy bulb - which bulb do I need - broken bulb - faulty bulb
bespoke refills - bespoke colours - custom colours - custom refills - bottle colours - custom lava colours - bespoke lava colours - bespoke bottle colours - special colours
bespoke refills - bespoke colours - custom colours - custom refills - bottle colours - custom lava colours - bespoke lava colours - bespoke bottle colours - special colours
strange lava - lava sticks
lava lamp broken - lava lamp doesn't work - broken bulb - faulty bulb
usa lava lamps - canada lava lamps - lava lamps usa - lava lamps canada - america lava lamps - lava lamps america - lava lamp usa
liquid clear - clear liquid
liquid low - liquid refill - top up liquid
bespoke bottles - special bottles - custom bottles - custom colour
jet lava lamp broken - jet lava lamp replacement - jet replacement
metal coil in bottle - metal spring in bottle
bottle doesn't fit - bottle won't fit - wonky bottle
hair in lava lamp - hair in bottle - dirt in bottle - dirt in lava lamp
clean lava lamp - polish lava lamp
bottle smashed - smashed bottle
bayonet bulb
smart astro replacement - broken smart astro - faulty smart astro
bottle copper lava lamp
replace - change bottle - ordered wrong bottle
refill - liquid refill - refill liquid - refill bottle - bottle refill - buy liquid refill - buy bottle refill - buy new liquids - buy new wax - buy new lava
how long bottle - how long bulb - broken bulb - faulty bulb
telstar american - american telstar - rocket lava lamp - bulb telstar - telstar bulb usa
three in one - 3 in one - 3 in 1
telstar rubber feet - telstar replacements - rubber feet telstar - rubber feet rocket
fluidium parts - fluidium replacements
dimmer lunar - lunar dimmer
age limit - kids
jet bottle - bottle jet
lunar bottle - rocket bottle - bottle lunar
brand - logo - where
gap - base - bottle - rim